Siemens SINUMERIK 840D Diagnostics Manual page 406

1 Alarms
Reactions:
Remedy:
Program Continuation:
27224
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
27225
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
27240
Parameters:
Definitions:
1-406
- Mode group not ready.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Check the module in the S7 PROFIBUS configuration.
Switch control OFF - ON.
PROFIsafe: F module MD %1[%2] - MD %3[%4]: double assignment of PROFIsafe
address
%1 = MD name 1
%2 = MD array index 1
%3 = MD name 2
%4 = MD array index 2
In the NCK MD or in the S7 F parameters, the same PROFIsafe address has been
parameterized for the F modules parameterized in the specified machine data. Therefore,
no clear communication link is possible between F master and F slave.
- Mode group not ready.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Check and correct the S7 F parameterization and NCK MD.
Switch control OFF - ON.
PROFIsafe: slave %1, configuration error %2
%1 = PROFIBUS slave address
%2 = Configuration error
An error occurred during the evaluation of the S7 PROFIBUS configuration for the speci-
fied slave. This is further specified in alarm parameter %2.
%2 = PRM header: the PRM telegram for this slave could not clearly be interpreted.
- Mode group not ready.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Check and correct the S7 PROFIBUS configuration.
Switch control OFF - ON.
PROFIsafe: DP M not running up, DP info: %1
%1 = Current information from the DP interface NCK-PLC
There is no DP configuration available to the NCK after the time specified via the MD
$MN_PLC_RUNNINGUP_TIMEOUT.
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04