Siemens SINUMERIK 840D Diagnostics Manual page 421

10.04
61105
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61106
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61107
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61108
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
Channel %1 block %2 cutter radius too large
%1 = Channel number
%2 = Block number, label
The diameter of the cutter used is too large for the form to be machined. Alarm triggered
by following cycles: SLOT1, SLOT2, POCKET1 to POCKET4, LONGHOLE, CYCLE90.
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Either a tool with a smaller radius has to be used or the contour must be modified.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 number or distance of circular elements
%1 = Channel number
%2 = Block number, label
Incorrect parameterization of NUM or INDA. The layout of the circle elements within a full
circle is not possible. Alarm triggered by following cycles: HOLES2, LONGHOLE, SLOT1,
SLOT2.
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Correct parameterization.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 first drilling depth incorrectly defined
%1 = Channel number
%2 = Block number, label
First drilling depth is in the opposite direction to the total drilling depth. Alarm triggered by
following cycle: CYCLE83.
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Modify drilling depth.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 illegal values for parameters _RAD1 and _DP1
%1 = Channel number
%2 = Block number, label
The parameters _RAD1 and _DP for defining the path for the depth infeed have been
incorrectly specified. Alarm triggered by following cycles: POCKET3, POCKET4.
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Modify parameter.
Clear alarm with the RESET key. Restart part program
1 Alarms
1-421