Philips CARDIOMD Service Manual page 249

Wall-mount Option
Installing the wall-mounted acquisition PC involves the following steps:
1. Unpacking the wall-mount kit
2. Mounting the base on the wall
3. Assembling the wall-mount kit
4. Routing cable to the gantry and applying wiremolds
5. Connecting the cable from the wall mount to the gantry.
After unpacking the wall-mount kit, proceed as follows to determine the position for the wall-
mounted laptop and to mount the base of the wall mount kit to the wall:
Procedure
1. Determine where the wall-mounted laptop
acquisition PC should be located.
If in doubt of where to place the laptop PC in
order to ensure a convenient workflow,
discuss its position with the customer.
In determining the position, consider that the
arm extends when the platform is rotated over
the 180° arc. This is of particular importance
when installing in small rooms where the
laptop may block entrances or passageways
when swung.
In small rooms, it is recommended always to
have the laptop arm folded against the wall.
2. Check that the cable from the wall-
mounting kit to the gantry is sufficiently
long to be routed nicely in the wiremolds
supplied as part of the wall-mount option.
If the cable is too short, you must find an
alternative position for the wall-mounted
acquisition PC closer to the gantry.
CAUTION
Note. It is recommended that the laptop is mounted on the wall at a height of approximately 40"
above the floor, which is suitable for most people. However, discuss the mounting height with the
customer to determine the best compromise.
1MAN0158-H11 04-2005 CSIP Level 1
Details
Arm folded against wall
Caution. When installing the wall-mount option for the CardioMD acquisition
PC, at least one vertical edge of the wall mounting plate must be secured to
stud. Installing the wall mounting plate only to drywall may cause drywall
fracture.
Installation
Arm extended
CardioMD Service Manual 8-47