Philips CARDIOMD Service Manual page 250

Installation
Procedure
After determining the position of the wall-
mount:
3. Hold the mounting plate towards the wall
and mark the upper right or left mounting
hole.
Note. The wall mounting plate must be installed with the split ring closest to floor.
Procedure
If the screw will be placed in a stud:
4. Use a 2 mm drill to drill the hole.
5. Mount the plate with this first screw.
If working in drywall, you must use the
dedicated screws and anchors supplied with
the kit (see photo on the right):
4. Drill a pilot hole and then use a 10 mm
drill for the final hole.
5. Remove the screw from the anchor and
insert the anchor in the hole just drilled in
the wall. Seat the anchor firmly into the
drywall by tapping with a hammer.
6. Fasten the mounting plate with the first
screw.
8-48 CardioMD Service Manual
Details
Details
Split ring
1MAN0158-H11 04-2005 CSIP Level 1