Replacing Collision Sensors - Philips CARDIOMD Service Manual

Repair Procedures

12.5.3.7 Replacing Collision Sensors

Collision sensors for the line source compartment are provided in pairs (assemblies). One
assembly, the longer one, is located furthest away from the motor. The shorter assembly is located
at the motor end of the line source compartment. The procedure for replacing both assemblies is
the same.
Procedure
1. Use a T08 Torx key to unscrew the two
collision sensors from the line source
compartment.
2. Locate the orange connector on top of the
motion controller.
3. Unplug the connection to the AC source
motion board.
12-66 CardioMD Service Manual
Details
Orange connector
Disconnect
1MAN0158-H11 04-2005 CSIP Level 1