Philips CARDIOMD Service Manual page 263

Desk-mount Option
Installing the desk-mount acquisition PC option comprises the following steps:
1. Unpacking the desk-mount kit.
2. Positioning and connecting the desk-mounted laptop PC.
3. Routing cable to gantry and applying wiremolds
4. Connecting the cable from the desk mount to the gantry.
After unpacking the desk-mount kit, proceed as follows to connect the laptop PC:
Procedure
1. Locate the laptop PC power supply.
2. Connect the power supply to the IEC
power connector.
The PC power cable can be threaded through
the hole on the rear side of the desk-mount,
allowing the power supply to be positioned
behind the desk-mount.
3. Route the PC power cable to the front of
the desk-mount and connect it to the
laptop PC's power input.
4. Connect the FireWire cable to the
FireWire connector on the laptop PC.
5. Connect the DB9 connector to the laptop
PC's monitor output.
This connection is only required to ground the
laptop PC for EMI/EMC reasons.
6. Connect the Ethernet cable to the laptop
PC's network connector.
7. Connect the external mouse to a USB port
on the laptop PC.
8. Connect the hand controller to the DB25
connector on the rear side of the desk-
mount top plate, next to the E-Stop button.
1MAN0158-H11 04-2005 CSIP Level 1
Details
Power cable
Ground connector
FireWire cable
Installation
Ethernet cable
CardioMD Service Manual 8-61