ABB +N5600 Firmware Instructions page 153

No. Name/Value
01.13 Output voltage
0...2000 V
01.14 Output power
-32768.00 ...
32767.00 kW or hp
01.15 Output power % of
motor nom
-300.00 ... 300.00% Output power.
01.17 Motor shaft power
-32768.00 ...
32767.00 kW or hp
01.18 Inverter GWh
motoring
0...32767 GWh
01.19 Inverter MWh
motoring
0...999 MWh
01.20 Inverter kWh
motoring
0...999 kWh
01.21 U-phase current
-30000.00 ...
30000.00 A
01.22 V-phase current
-30000.00 ...
30000.00 A
01.23 W-phase current
-30000.00 ...
30000.00 A
01.24 Flux actual %
0...200%
01.29 Speed change rate
-15000 ... 15000
rpm/s
Description
Calculated motor voltage in V AC.
Motor voltage.
Drive output power. The unit is selected by parameter
Unit selection. A filter time constant for this signal can be
defined by parameter 46.14 Filter time power
Output power.
Shows the value of 01.14 Output power
nominal power of the motor.
Estimated mechanical power at motor shaft. The unit is
selected by parameter 96.16 Unit
constant for this signal can be defined by parameter
Filter time power out.
Motor shaft power.
Amount of energy that has passed through the drive (towards
the motor) in full gigawatt-hours. The minimum value is zero.
Motoring energy in GWh.
Amount of energy that has passed through the drive (towards
the motor) in full megawatt-hours. Whenever the counter rolls
over, 01.18 Inverter GWh motoring
minimum value is zero.
Motoring energy in MWh.
Amount of energy that has passed through the drive (towards
the motor) in full kilowatt-hours. Whenever the counter rolls
over, 01.19 Inverter MWh motoring
minimum value is zero.
Motoring energy in kWh.
Measured U-phase current.
U-phase current.
Measured V-phase current.
V-phase current.
Measured W-phase current.
W-phase current.
Used flux reference in percent of nominal flux of motor.
Flux reference.
Rate of actual speed change. Positive values indicate
acceleration, negative values indicate deceleration.
See also parameters 31.32 Emergency ramp
31.33 Emergency ramp supervision
supervision and 31.38 Ramp stop supervision
Rate of speed change.
Parameters 153
96.16
out.
in percent of the
selection. A filter time
46.14
is incremented.The
is incremented.The
supervision,
delay, 31.37 Ramp stop
delay.
Def/FbEq16
-
1 = 1 V
-
1 = 1 unit
-
10 = 1%
-
1 = 1 unit
-
1 = 1 GWh
-
1 = 1 MWh
-
10 = 1 kWh
-
See par.
46.05
-
See par.
46.05
-
See par.
46.05
-
1 = 1%
-
1 = 1 rpm/s