ABB +N5600 Firmware Instructions page 238

238 Parameters
No. Name/Value
20.07 Ext2 start trigger
type
Edge
Level
20.08 Ext2 in1 source
20.09 Ext2 in2 source
20.10 Ext2 in3 source
20.11 Run enable stop
mode
Coast
Ramp
Torque limit
20.12 Run enable 1
source
Not selected
Selected
DI1
DI2
DI3
DI4
DI5
DI6
DIO1
DIO2
FBA A MCW bit 3
EFB MCW bit 3
Description
Defines whether the start signal for external control location
EXT2 is edge-triggered or level-triggered.
Note: This parameter is only effective when parameter
Ext2 commands is set to
fwd; In2 Start rev, or Control
The start signal is edge-triggered.
The start signal is level-triggered.
Selects source 1 for parameter
For the available selections, see parameter
source.
Selects source 2 for parameter
For the available selections, see parameter
source.
Selects source 3 for parameter
For the available selections, see parameter
source.
Selects the way the motor is stopped when the run enable
signal switches off.
The source of the run enable signal is selected by parameter
20.12 Run enable 1 source.
Stop by switching off the output semiconductors of the drive.
The motor coasts to a stop.
WARNING! If a mechanical brake is used, ensure it is
safe to stop the drive by coasting.
Stop along the active deceleration ramp. See parameter
group 23 Speed reference ramp
Stop according to torque limits (parameters
Selects the source of the external run enable signal. If the run
enable signal is switched off, the drive will not start. If already
running, the drive will stop according to the setting of
parameter 20.11 Run enable stop
1 = Run enable signal on.
Note: The warning that indicates a missing signal can be
suppressed using parameter
function.
See also parameter 20.19 Enable start
0.
1.
Digital input DI1 (10.02 DI delayed
Digital input DI2 (10.02 DI delayed
Digital input DI3 (10.02 DI delayed
Digital input DI4 (10.02 DI delayed
Digital input DI5 (10.02 DI delayed
Digital input DI6 (10.02 DI delayed
Digital input/output DIO1
Digital input/output DIO2
Control word bit 3 received through fieldbus interface A.
Control word bit 3 received through the embedded fieldbus
interface.
In1 Start, In1 Start; In2 Dir,
panel.
20.06 Ext2 commands.
20.03 Ext1 in1
20.06 Ext2 commands.
20.03 Ext1 in1
20.06 Ext2 commands.
20.03 Ext1 in1
on page 257.
30.19
mode.
20.30 Enable signals warning
command.
status, bit 0).
status, bit 1).
status, bit 2).
status, bit 3).
status, bit 4).
status, bit 5).
(11.02 DIO delayed status, bit 0).
(11.02 DIO delayed status, bit 1).
Def/FbEq16
Edge
20.06
In1 Start
0
1
Not selected
Not selected
Not selected
Coast
(95.20 b10)
0
1
and 30.20). 2
DIIL
(95.20 b10);
Selected
(95.20 b5);
DI5
(95.20 b9)
0
1
2
3
4
5
6
7
10
11
30
32