ABB +N5600 Firmware Instructions page 182

182 Parameters
No. Name/Value
07.30 Adaptive program
status
Bit Name
0 Initialized
1 Editing
2 Edit done
3 Running
4...13 Reserved
14 State changing
15 Faulted
0000h...FFFFh
07.40 IEC application Cpu
usage peak
0.0 ... 100.0%
07.41 IEC application Cpu
load average
0.0 ... 100.0%
07.106 LSU loading
package name
07.107 LSU loading
package version
Description
Shows the status of the adaptive program.
See section Adaptive programming
Description
1 = Adaptive program initialized
1 = Adaptive program is being edited
1 = Editing of adaptive program finished
1 = Adaptive program running
1 = State change in progress in adaptive programming engine
1 = Error in adaptive program
Adaptive program status.
(Only visible with option +N8010 [application
programmability])
Displays the peak loading of the microprocessor caused by
the application program. This parameter can, for example, be
used to check the effect of a given application program
functionality on the CPU load.
The value is in percent of an internally-defined quota.
Can be reset from the control panel by keeping Reset
depressed for over 3 seconds.
Peak microprocessor loading caused by application program. 10 = 1%
(Only visible with option +N8010 [application
programmability])
Displays the average loading of the microprocessor caused
by the application program. The value is in percent of an
internally-defined quota.
Average microprocessor loading caused by application
program.
(Only visible when IGBT supply unit control activated by
95.20)
Name of the loading package of the supply unit firmware.
(Only visible when IGBT supply unit control activated by
95.20)
Version number of the loading package of the supply unit
firmware.
(page 63).
Def/FbEq16
-
1 = 1
-
-
10 = 1%
-
-