Default Parameter Settings For The Pid Control Macro - ABB +N5600 Firmware Instructions



Default parameter settings for the PID control macro

Below is a listing of default parameter values that differ from those listed for the
Factory macro in Parameter listing
Parameter
No. Name
12.27 AI2 min
19.11 Ext1/Ext2 selection
20.01 Ext1 commands
20.04 Ext1 in2 source
20.06 Ext2 commands
20.08 Ext2 in1 source
20.12 Run enable 1 source
22.12 Speed ref2 source
22.22 Constant speed sel1
23.11 Ramp set selection
31.11 Fault reset selection
40.07 Set 1 PID operation mode
40.08 Set 1 feedback 1 source
40.11 Set 1 feedback filter time
40.35 Set 1 derivation filter time
40.60 Set 1 PID activation source
Note: The macro selection does not affect parameter group
(page 152).
PID control macro default
4.000
DI3
In1 Start
Not selected
In1 Start
DI6
DI5
PID
DI4
Acc/Dec time 1
Not selected
On when drive running
AI2 scaled
0.040 s
1.0 s
Follow Ext1/Ext2 selection
Application macros 137
41 Process PID set 2.