ABB +N5600 Firmware Instructions page 372

372 Parameters
No. Name/Value
Warning
49.06 Refresh settings
Done
Refresh
49.07 Panel comm
supervision force
Bit Name
0 Ext 1
1 Ext 2
2 Local
3...15 Reserved
0000b...0111b
49.08 Secondary comm.
loss action
No action
Warning
49.14 Panel speed
reference unit
rpm
%
49.15 Minimum ext speed
ref panel
-30000.00 ...
30000.00 rpm
Description
Drive generates an A7EE Control panel loss
only occurs if control is expected from the control panel, or if
supervision is forced using parameter
supervision force.
WARNING! Make sure that it is safe to continue
operation in case of a communication break.
Applies the settings of parameters 49.01...49.05.
Note: Refreshing may cause a communication break, so
reconnecting the drive may be required.
Refresh done or not requested.
Refresh parameters 49.01...49.05. The value reverts
automatically to Done.
Activates control panel communication monitoring separately
for each control location (see section
external control on page 24).
The parameter is primarily intended for monitoring the
communication with the panel when it is connected to the
application program and not selected as a control source by
drive parameters.
Value
1 = Communication monitoring active when Ext 1 is being used.
1 = Communication monitoring active when Ext 2 is being used.
1 = Communication monitoring active when local control is being
used.
Panel communication monitoring selection.
Selects how the drive reacts to a control panel (or PC tool)
communication break. This action is taken when
• the panel is parametrized as an alternative control or
reference source but is not currently the active source, and
• communication supervision for the active control location is
not forced by parameter
force.
No action taken.
Drive generates an A7EE Control panel loss
WARNING! Make sure that it is safe to continue
operation in case of a communication break.
Defines the unit for speed reference when given from the
control panel.
rpm.
Percent of absolute value of
Minimum speed, whichever is greater.
Defines a minimum limit for control panel speed reference in
external control.
In local control, the limits in parameter group
force. See section Local control vs. external control
24).
Minimum speed reference.
warning. This
49.07 Panel comm
Local control vs.
49.07 Panel comm supervision
warning.
30.12 Maximum speed
30 Limits
Def/FbEq16
5
Done
0
1
0000b
1 = 1
No action
0
5
rpm
0
or 30.11 1
-30000.00
rpm
are in
(page
See par.
46.01