ABB +N5600 Firmware Instructions page 478

478 Parameters
No. Name/Value
95.21 HW options word 2
Bit Name
0 Dual use
1 SynRM
2 Salient PM
3...15 Reserved
0000b...0011b
95.30 Parallel type filter
All types
-3 (380-415V)
-5 (380-500V)
-7 (525-690V)
95.31 Parallel connection
rating id
Not selected
[Drive/inverter type] Drive/inverter type consisting of parallel-connected modules.
95.35 Adjustable supply
voltage
Disable
Enable
Description
Specifies more hardware-related options that require
differentiated parameter defaults. See parameter
options word 1.
WARNING! After switching any bits in this word,
recheck the values of the affected parameters.
Information
1 = Dual use active. For drives with option +N8200. (Allows higher
output frequencies and frequency reference limits.)
1 = Synchronous reluctance motor used. Affects parameters 25.02,
25.03, 25.15, 99.03, 99.13.
1 = Salient-pole permanent magnet motor used. Affects parameters
25.02, 25.03, 25.15, 99.03, 99.13.
Hardware options configuration word 2.
(Only visible with a BCU control unit)
Filters the list of drive/inverter types listed by parameter
Parallel connection rating
All types listed.
-3 (380...415 V) types listed.
-5 (380...500 V) types listed.
-7 (525...690 V) types listed.
(Only visible with a BCU control unit)
Defines the drive/inverter type if it consists of parallel-
connected modules.
If the drive/inverter consists of a single module, leave the
value at Not selected.
The drive/inverter does not consist of parallel-connected
modules, or type not selected.
Enables manual setting for the supply voltage limits with
parameters 95.36 Supply voltage low
voltage high.
Note: Enabling Adjustable supply voltage limits overrides
limits based on 95.01 Supply voltage
voltage limits. This affects other soft limits in the drive
associated with the supply voltage.
WARNING! An incorrect setting may cause the motor
to rush uncontrollably, or the brake chopper or resistor
to overload.
Adjustable supply voltage is disabled.
Adjustable supply voltage is enabled.
95.20 HW
id.
and 95.37 Supply
or 95.02 Adaptive
Def/FbEq16
-
1 = 1
All types
95.31
0
1
2
3
Not selected
0
-
Disable
0
1