ABB +N5600 Firmware Instructions page 583

Code
Warning
(hex)
A889 Edge counter 2
(Editable message text)
Programmable warning:
33.45 Edge counter 2
warn message
A88A Value counter 1
(Editable message text)
Programmable warning:
33.55 Value counter 1
warn message
A88B Value counter 2
(Editable message text)
Programmable warning:
33.65 Value counter 2
warn message
A88C Device clean
A88D DC capacitor
A88E Cabinet fan
A88F Cooling fan
A890 Additional cooling
A8A0 AI supervision
Programmable warning:
12.03 AI supervision
function
A8B0 Signal supervision
(Editable message text)
Programmable warning:
32.06 Supervision 1 action
A8B1 Signal supervision 2
(Editable message text)
Programmable warning:
32.16 Supervision 2 action
A8B2 Signal supervision 3
(Editable message text)
Programmable warning:
32.26 Supervision 3 action
A8BE ULC overload warning
Programmable fault:
37.03 ULC overload
actions
Cause
Warning generated by edge
counter 2.
Warning generated by value
counter 1.
Warning generated by value
counter 2.
Warning generated by an on-
time timer.
Programmable warnings:
33.14 On-time 1 warn message
33.24 On-time 2 warn message
An analog signal is outside the
limits specified for the analog
input.
Warning generated by the
signal supervision 1 function.
Warning generated by the
signal supervision 2 function.
Warning generated by the
signal supervision 3 function.
Selected signal has exceeded
the user overload curve.
Fault tracing 583
What to do
Check the source of the warning
(parameter 33.43 Edge counter 2
source).
Check the source of the warning
(parameter 33.53 Value counter 1
source).
Check the source of the warning
(parameter 33.63 Value counter 2
source).
Check the auxiliary code. Check the
source of the warning corresponding to
the code:
0: 33.13 On-time 1 source
1: 33.23 On-time 2 source
10: 05.04 Fan on-time counter.
Check the auxiliary code (format XYY).
"X" specifies the location of the input (0:
AI on control unit; 1: I/O extension
module 1, etc.), "YY" specifies the input
and limit (01: AI1 under minimum,
02: AI1 over maximum, 03: AI2 under
minimum, 04: AI2 over maximum).
Check signal level at the analog input.
Check the wiring connected to the input.
Check the minimum and maximum limits
of the input in parameter group
Standard AI, 14 I/O extension module
15 I/O extension module 2
extension module 3.
Check the source of the warning
(parameter 32.07 Supervision 1
Check the source of the warning
(parameter 32.17 Supervision 2
Check the source of the warning
(parameter 32.27 Supervision 3
Check for any operating conditions
increasing the monitored signal (for
example, the loading of the motor if the
torque or current is being monitored).
Check the definition of the load curve
(parameter group 37 User load
12
1,
or 16 I/O
signal).
signal).
signal).
curve).