ABB +N5600 Firmware Instructions page 262

262 Parameters
No. Name/Value
23.28 Variable slope
enable
Off
On
Other [bit]
23.29 Variable slope rate
2...30000 ms
23.39 Follower speed
correction out
-30000.00 ...
30000.00 rpm
23.40 Follower speed
correction enable
Not selected
Selected
DI1
DI2
Description
Activates the variable slope function, which controls the slope
of the speed ramp during a speed reference change. This
allows for a constantly variable ramp rate to be generated,
instead of just the standard two ramps normally available.
If the update interval of the signal from an external control
system and the variable slope rate
are equal, the resulting speed reference
ramp output) is a straight line.
Speed reference
Speed
reference
t
A
t = update interval of signal from external control system
A = speed reference change during t
This function is only active in remote control.
Variable slope disabled.
Variable slope enabled (not available in local control).
Source selection (see Terms and abbreviations
Defines the rate of the speed reference change when variable
slope is enabled by parameter
For the best result, enter the reference update interval into
this parameter.
Variable slope rate.
Displays the speed correction term for the load share function
with a speed-controlled follower drive.
See section Load share function with a speed-controlled
follower (page 69).
This parameter is read-only.
Speed correction term.
With a speed-controlled follower, selects the source for
enabling/disabling the load share function.
See section Load share function with a speed-controlled
follower (page 69).
0 = Disabled
1 = Enabled
0.
1.
Digital input DI1 (10.02 DI delayed
Digital input DI2 (10.02 DI delayed
(23.29 Variable slope
(23.02 Speed ref
23.02 Speed ref ramp output
on page 148). -
23.28 Variable slope
status, bit 0).
status, bit 1).
Def/FbEq16
Off
rate)
Time
0
1
50 ms
enable.
1 = 1 ms
-
See par.
46.01
Not selected
0
1
2
3