ABB +N5600 Firmware Instructions page 188

188 Parameters
No. Name/Value
10.15 DI6 ON delay
*DI status
**Delayed DI status
t = 10.15 DI6 ON delay
On
t = 10.16 DI6 OFF delay
Off
*Electrical status of digital input. Indicated by
**Indicated by 10.02 DI delayed
0.0 ... 3000.0 s
10.16 DI6 OFF delay
0.0 ... 3000.0 s
10.21 RO status
0000h...FFFFh
10.24 RO1 source
Not energized
Energized
Ready run
Enabled
Started
Magnetized
Running
Ready ref
At setpoint
Reverse
Zero speed
Above limit
Warning
Fault
Fault (-1)
Open brake
command
Ext2 active
Description
Defines the activation delay for digital input DI6.
t t
On Off
10.01 DI
status.
Activation delay for DI6.
Defines the deactivation delay for digital input DI6. See
parameter 10.15 DI6 ON
Deactivation delay for DI6.
Status of relay outputs RO8...RO1. Example: 00000001b =
RO1 is energized, RO2...RO8 are de-energized.
Status of relay outputs.
Selects a drive signal to be connected to relay output RO1.
Output is not energized.
Output is energized.
Bit 1 of 06.11 Main status word
Bit 0 of 06.16 Drive status word 1
Bit 5 of 06.16 Drive status word 1
Bit 1 of 06.17 Drive status word 2
Bit 6 of 06.16 Drive status word 1
Bit 2 of 06.11 Main status word
Bit 8 of 06.11 Main status word
Bit 2 of 06.19 Speed control status word
Bit 0 of 06.19 Speed control status word
Bit 10 of 06.17 Drive status word 2
Bit 7 of 06.11 Main status word
Bit 3 of 06.11 Main status word
Inverted bit 3 of 06.11 Main status word
Bit 0 of 44.01 Brake control status
Bit 11 of 06.16 Drive status word 1
t
On
status.
delay.
(see page 166).
(see page 167).
(see page 167).
(see page 168).
(see page 167).
(see page 166).
(see page 166).
(see page 170).
(see page 170).
(see page 168).
(see page 166).
(see page 166).
(see page 166).
(see page 357).
(see page 167).
Def/FbEq16
0.0 s
1
0
1
0
Time
t
Off
10 = 1 s
0.0 s
10 = 1 s
-
1 = 1
Ready run;
10.01 b3 (-1)
(95.20 b2);
35.105 b1
(95.20 b6);
06.16 b6
(95.20 b9)
0
1
2
4
5
6
7
8
9
10
11
12
13
14
15
22
23