Drive Configuration And Programming; Programming Via Parameters - ABB +N5600 Firmware Instructions

62 Program features

Drive configuration and programming

The drive control program is divided into two parts:
• firmware program
• application program.
Application program
Function block
program
Standard
block library
The firmware program performs the main control functions, including speed and
torque control, drive logic (start/stop), I/O, feedback, communication and protection
functions. Firmware functions are configured and programmed with parameters, and
can be extended by application programming.


Programming via parameters

Parameters configure all of the standard drive operations and can be set via
• the control panel, as described in chapter
• the Drive composer PC tool, as described in Drive composer user's manual
(3AUA0000094606 [English]), or
• the fieldbus interface, as described in chapters
embedded fieldbus interface (EFB)
adapter.
All parameter settings are stored automatically to the permanent memory of the drive.
However, if an external +24 V DC power supply is used for the drive control unit, it is
highly recommended to force a save by using parameter
manually before powering down the control unit after any parameter changes have
been made.
If necessary, the default parameter values can be restored by parameter
Parameter restore.
Drive control program
Speed control
Torque control
Frequency control
Parameter
Drive logic
interface
I/O interface
Fieldbus interface
Protections
Feedback
and
Firmware
Using the control panel
Fieldbus control through the
Fieldbus control through a fieldbus
96.07 Parameter save
M
96.06