ABB +N5600 Firmware Instructions page 36

36 Quick start-up guide
Configure analog outputs if used for drive
control:
Parameter 13.12
analog output AO1 (by default, motor speed
in rpm).
Parameters 13.17
high source signal values that correspond to
the actual analog output values defined in
parameters 13.19
13.18
13.19
Set desired source for the fault reset
command.
Set the maximum frequency value used to
define the acceleration ramp rate.
The initial frequency value is used to define
deceleration ramp rate (see parameter group
28 Frequency reference
frequency acceleration and deceleration
ramp times are therefore related to this value
(not to parameter
frequency). Also defines the 16-bit scaling of
frequency-related parameters. The value of
this parameter corresponds to 20000 in
fieldbus, master/follower etc.
communication.
– select the source for
and 13.18 – set low and
and 13.20.
Source signal
AO (mA)
13.20
13.17
4 – Scaling settings
chain). The
30.14 Maximum
13.12 AO1 source
13.17 AO1 source min
13.18 AO1 source max
13.19 AO1 out at AO1 src min
13.20 AO1 out at AO1 src max
31.11 Fault reset selection
46.02 Frequency scaling