ABB +N5600 Firmware Instructions page 214

214 Parameters
No. Name/Value
14.38 RO2 ON delay
0.00 ... 3000.00 s
14.39 RO2 OFF delay
0.00 ... 3000.00 s
14.41 AI2 actual value
-22.000 ... 22.000
mA or V
14.42 AI2 scaled value
-32768.000 ...
32767.000
14.43 AI2 force data
-22.000 ... 22.000
mA or V
14.44 AI2 HW switch
position
V
mA
14.45 AI2 unit selection
V
mA
14.46 AI2 filter gain
No filtering
Description
(Visible when 14.01 Module 1 type
Defines the activation delay for relay output RO2. See
parameter 14.35 RO1 ON
Activation delay for RO2.
(Visible when 14.01 Module 1 type
Defines the deactivation delay for relay output RO2. See
parameter 14.35 RO1 ON
Deactivation delay for RO2.
(Visible when 14.01 Module 1 type
Displays the value of analog input AI2 in mA or V (depending
on whether the input is set to current or voltage).
This parameter is read-only.
Value of analog input AI2.
(Visible when 14.01 Module 1 type
Displays the value of analog input AI2 after scaling. See
parameter 14.50 AI2 scaled at AI2
This parameter is read-only.
Scaled value of analog input AI2.
(Visible when 14.01 Module 1 type
Forced value that can be used instead of the true reading of
the input. See parameter
Forced value of analog input AI2.
(Visible when 14.01 Module 1 type
Shows the position of the hardware current/voltage selector
on the I/O extension module.
Note: The setting of the current/voltage selector must match
the unit selection made in parameter
I/O module reboot either by cycling the power or through
parameter 96.08 Control board boot
any changes in the hardware settings.
Volts.
Milliamperes.
(Visible when 14.01 Module 1 type
Selects the unit for readings and settings related to analog
input AI2.
Note: This setting must match the corresponding hardware
setting on the I/O extension module (see the manual of the
I/O extension module). The hardware setting is shown by
parameter 14.44 AI2 HW switch
either by cycling the power or through parameter
Control board boot is required to validate any changes in the
hardware settings.
Volts.
Milliamperes.
(Visible when 14.01 Module 1 type
Selects a hardware filtering time for AI2.
See also parameter 14.47 AI2 filter
No filtering.
= FIO-01 or FDIO-01)
delay.
= FIO-01 or FDIO-01)
delay.
= FIO-11 or FAIO-01)
= FIO-11 or FAIO-01)
min.
= FIO-11 or FAIO-01)
14.22 AI force selection.
= FIO-11 or FAIO-01)
14.45 AI2 unit
is required to validate
= FIO-11 or FAIO-01)
position. I/O module reboot
= FIO-11 or FAIO-01)
time.
Def/FbEq16
0.00 s
10 = 1 s
0.00 s
10 = 1 s
-
1000 = 1 mA
or V
-
1 = 1
0.000 mA
1000 = 1 mA
or V
-
selection.
2
10
mA
96.08
2
10
1 ms
0