ABB +N5600 Firmware Instructions page 237

No. Name/Value
In1P Start; In2 Stop;
In3 Dir
In1P Start fwd; In2P
Start rev; In3 Stop
Control panel
Fieldbus A
Embedded fieldbus
M/F link
Application
Program
ATF
DDCS controller
Description
The sources of the start and stop commands are selected by
parameters 20.08 Ext2 in1 source
The source selected by
direction. The state transitions of the source bits are
interpreted as follows:
State of State of
source 1 source 2
(20.08) (20.09)
0 - > 1
1
0 - > 1
1
Any 0
Note: The start signal is always edge-triggered with this
setting regardless of parameter
The sources of the start and stop commands are selected by
parameters 20.08 Ext2 in1
20.10 Ext2 in3 source. The state transitions of the source bits
are interpreted as follows:
State of State of
source 1 source 2
(20.08) (20.09)
0 - > 1
Any
0 - > 1
Any
Any Any
Note: The start signal is always edge-triggered with this
setting regardless of parameter
The start and stop commands are taken from the control
panel.
The start and stop commands are taken from fieldbus adapter
A.
Note: The start signal is always level-triggered with this
setting regardless of parameter
The start and stop commands are taken from the embedded
fieldbus interface.
Note: The start signal is always level-triggered with this
setting regardless of parameter
The start and stop commands are taken from another drive
through the master/follower link.
Note: The start signal is always level-triggered with this
setting regardless of parameter
The start and stop commands are taken from the application
program control word (parameter
word).
Note: The start signal is always level-triggered with this
setting regardless of parameter
Reserved.
The start and stop commands are taken from an external
(DDCS) controller.
Note: The start signal is always level-triggered with this
setting regardless of parameter
and 20.09 Ext2 in2
20.10 Ext2 in3 source determines the
State of
source 3
(20.10)
0 Start forward
1 Start reverse
Any
20.07 Ext2 start trigger
source, 20.09 Ext2 in2 source
State of
source 3
(20.10)
1 Start forward
1 Start reverse
0
20.07 Ext2 start trigger
20.07 Ext2 start trigger
20.07 Ext2 start trigger
20.07 Ext2 start trigger
06.02 Application control
20.07 Ext2 start trigger
20.07 Ext2 start trigger
Parameters 237
Def/FbEq16
5
source.
Command
Stop
type.
6
and
Command
Stop
type.
11
12
type.
14
type.
15
type.
21
type.
22
16
type.