Huawei OptiX OSN 550 Configuration Manual page 140

3 Configuring SDH Services
Step 4 Configure the pass-through services of NE1. Refer to
NE1. The method and parameters for configuring the pass-through services of NE1 are the same
as the method and parameters for configuring the pass-through services of NE2.
Step 5 Configure the services on the non-protection chain at NE5.
1.
2.
3.
3-58
Parameter Value in
This
Example
Source 1-5
Timeslot
Range(e.g.
1,3-6)
Sink Slot 1-SL4D-1
(SDH-1)
Sink VC4 VC4-1
Sink 1-5
Timeslot
Range(e.g.
1,3-6)
Activate Yes
Immediately
In the NE Explorer, click
Choose Configuration > SDH Service Configuration from the Function Tree.
Click Create on the lower-right pane to display the Create SDHP Service dialog box. Set
the parameters that are required, and then click OK.
Parameter Value in
This
Example
Level VC12
Direction Bidirectiona
l
Source Slot 3-SP3D
Source VC4 -
Source 1-5
Timeslot
Range(e.g.
1,3-6)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
OptiX OSN 550 Multi-Service CPE Optical Transmission
Description
In this example, five E1 services are configured between
NE3 and NE5. Hence, the working service source
occupies VC-12s 1-5.
In this example, the SL4D board in slot 1 of NE2 is
configured as the sink line board. See
In this example, the service sink uses the timeslots of
VC4-1.
In this example, five E1 services are configured between
NE3 and NE5. Hence, the service sink occupies VC-12s
1-5.
-
Step 3
, and then select NE5. Click OK.
Description
In this example, E1 services are configured. Hence,
Level of the E1 services is set to VC12.
In this example, Direction of the E1 services is set to
Bidirectional.
In this example, the SP3D board in slot 3 of NE5 is
configured as the source tributary board. See
3-16.
-
In this example, five E1 services are configured between
NE3 and NE5. Hence, the working service source
occupies VC-12s 1-5.
Configuration Guide
Figure 3-16.
and configure the SDH services of
Figure
Issue 02 (2011-06-30)
System