Huawei OptiX OSN 550 Configuration Manual page 235

OptiX OSN 550 Multi-Service CPE Optical Transmission
System
Configuration Guide
4.
Issue 02 (2011-06-30)
User Parameter
Sink Port
Sink C-
VLAN (e.g.
1, 3-6)
Configure the cross-connections from the Ethernet services to the SDH links for user D1
and user E1.
l In the NE Explorer, select NE1 and then choose Configuration > SDH Service
Configuration from the Function Tree.
l Click Create on the lower-right pane to display the Create SDH Service dialog box.
Set the parameters as follows.
User Paramete
r
User D1 Level
←→
user D2
user E1
←→
user E2
Service
Direction
Source Slot 4-EFS8-1
Source
VC4
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Value in Description
This
Example
VCTRUN When creating the bidirectional Ethernet
K1 service from a PORT to a VCTRUNK, it is
recommended that you use a specific
VCTRUNK as the sink port. In this example,
VCTRUNK1 is the internal port used by the
service between user E1 and user E2.
200 According to the plan, the VLAN ID is set to
200 on the transmission network side for
Ethernet service between user E1 and user E2.
Value in Description
This
Example
VC12 The timeslots bound with the service
between user D1 and user D2 and the
service between user E1 and user E2 are at
the VC-12 level. The service level must be
consistent with the level of the paths bound
with the VCTRUNK.
Bidirectiona The service between user D1 and user D2
l and the service between user E1 and user
E2 are bidirectional services.
When you create a bidirectional SDH
(SDH-1) service from an Ethernet board to a line
board, it is recommended that you set the
slot of the Ethernet board as the source slot.
VC4-4 The value range of Source VC4 is
consistent with the value range of
Available Resources, which is set for the
paths bound with VCTRUNK1. In this
example, Source VC4 is set to VC4-4.
4 Configuring Ethernet Services
4-81