Configuring The Broadcast Data Service - Huawei OptiX OSN 550 Configuration Manual

2 Creating the Network
2-SL4D-2
2-SL4D-1
Telephone No./
Conference Call No.
As shown in the preceding figure, if conference calls are configured for all optical interfaces,
howler tone is generated. You can configure a conference call for the optical interface NE3-2-
SL4D-2 only, instead of the optical interface NE3-2-SL4D-1.

2.10 Configuring the Broadcast Data Service

To meet the requirements for the broadcast data services between the monitoring host and the
environment monitors, you need to configure the broadcast data services of NE1-NE4.
Prerequisite
l
l
Precautions
When you configure the broadcast data ports, ensure that the broadcast data ports do not form
a loop. Certain optical ports cannot be configured as the broadcast data ports.
Procedure
Step 1 Select NE in the NE Explorer, and then choose Configuration > Orderwire from the Function
Tree.
Step 2 Click the Broadcast Data Port tab and set the parameters as listed in the following table. Then,
click Apply. For the values of specified parameters, see
Interfaces.
2-36
NM ID
NM name
IP address 192.9.0.54
2-SL4D-1
9-2
Two-fiber bidirectional
NE2
1002/9999
NE ID
2-SL4D-2
NE name
The 2 Creating the Network
Understand the signal flow and timeslot allocation.
CAUTION
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
OptiX OSN 550 Multi-Service CPE Optical Transmission
U2000
NM
2-SL4D-2
9-1
NE1
1001/9999
MSP ring
1004/9999
9-3
NE3
1003/9999
2-SL4D-1
task must be completed.
Configuration Guide
2-SL4D-1
1-SL1D-1 1-SL1D-1
9-4
NE4
Two-fiber
2-SL4D-2
bidirectional
2.12.3 Configuring Broadcast Data
Issue 02 (2011-06-30)
System
9-5
NE5
1005/9999