End-To-End Configuration Process - Huawei OptiX OSN 550 Configuration Manual

3 Configuring SDH Services
Step 4 Check whether the services are configured correctly. For details, see Verifying the Correctness
of the SDH Service Configuration.
Step 5 Enable the performance monitoring function of the NEs. For details, see Setting Performance
Monitoring Parameters of an NE.
Step 6 Back up the configuration data of the NEs. For details, see Backing Up the NE Database to the
SCB Board.
----End
Relevant Task
If the services are configured incorrectly and thus need to be deleted, see Deleting SDH Services.

3.10.4 End-to-End Configuration Process

The configuration of services on a two-fiber bidirectional MSP ring with a non-protection chain
is independent of the creation of protection subnets for the MSP and for the non-protection chain.
To configure services on a two-fiber bidirectional MSP ring with a non-protection chain,
configure SDH services from the tributary board to the line board on the source and sink NEs
and configure pass-through services on the intermediate NEs, if the protection subnet has already
been created. The following part describes how to configure services on an MSP ring with a
non-protection chain in an end-to-end manner.
Prerequisite
l
l
3-66
Parameter Value in
This
Example
Source VC4 VC4-1
Source 1-5
Timeslot Range
(e.g.1,3-6)
Sink Slot 2-SL1D-1
(SDH-1)
Sink VC4 VC4-1
Sink Timeslot 1-5
Range(e.g.
1,3-6)
Activate Yes
Immediately
The physical network topology must be set up.
NEs, boards, and fibers must be successfully created on the U2000.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
OptiX OSN 550 Multi-Service CPE Optical Transmission
Description
In this example, the service source uses the timeslots
of VC4-1.
In this example, five E1 services are configured
between NE3 and NE5. Hence, the service sink
occupies VC-12s 1-5.
In this example, the SL1D board in slot 2 of NE5 is
configured as the sink line board. See
In this example, the service sink uses the timeslots of
VC4-1.
In this example, five E1 services are configured
between NE3 and NE5. Hence, the service sink
occupies VC-12s 1-5.
-
System
Configuration Guide
Figure 3-18.
Issue 02 (2011-06-30)