Loopback Status (Oam Parameter); Flow Type (Flow Configuration) - Huawei OptiX OSN 550 Configuration Manual

7 List of Parameters

7.51 Loopback Status (OAM Parameter)

Description
The Loopback Status (OAM Parameter) parameter specifies whether a port on the board is
in the loopback state. If yes, the port is in the Initiate Loopback at Local or Respond Loopback
of Remote state.
Impact on the System
The system operation is not affected.
Values
Valid Values
Initiate Loopback at Local, Respond
Loopback of Remote, Non-Loopback
The following table lists the description of each value.
Value
Non-Loopback
Initiate Loopback at Local
Respond Loopback of Remote
Configuration Guidelines
None.
Relationship with Other Parameters
None.

7.52 Flow Type (Flow Configuration)

Description
The Flow Type(Flow Configuration) parameter specifies Flow Type of the flow in the Ethernet
data board. This parameter decides the method of binding the service with the flow.
7-46
OptiX OSN 550 Multi-Service CPE Optical Transmission
Description
Indicates that the port is not in the loopback state defined
in IEEE 802.3ah.
Indicates that the local end can transmit the loopback
packets to the remote end.
Indicates that the local end can respond to the loopback
packets from the remote end.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Default Value
Non-Loopback
System
Configuration Guide
Issue 02 (2011-06-30)