Basic Attributes; Table 4-36 Parameters For Configuring The Basic Attributes Of An Ethernet Port - Huawei OptiX OSN 550 Configuration Manual

OptiX OSN 550 Multi-Service CPE Optical Transmission
System
Configuration Guide
4.11.5 TAG Attributes
Tag attributes are important attributes that are used for configuring Ethernet services, including
the parameters such as the default VLAN ID, VLAN priority, ingress detection setting, and tag
ID.
4.11.6 Encapsulation/Mapping
The equipment supports the setting of encapsulation and mapping protocols for Ethernet packets,
including the parameters such as mapping protocol, scrambling code, and CRC or not.
4.11.7 Bound Path
This topic describes the parameters, such as available resources, available timeslots, and service
direction, which are used for binding a path with an Ethernet port.

4.11.1 Basic Attributes

This topic describes the parameters, such as the port attribute, port enabling status, and maximum
frame length, that are used for configuring the basic attributes of an Ethernet port.
Table 4-36
port.

Table 4-36 Parameters for configuring the basic attributes of an Ethernet port

Field
Port
Name
Enabled/Disabled
Working Mode
Issue 02 (2011-06-30)
lists the parameters that are used for configuring the basic attributes of an Ethernet
Value Range
PORTn
For example: PORT-1
Disabled, Enabled
Default value: Disabled
Auto-Negotiation, 100M Full-
Duplex, 1000M Full-Duplex
Default value: Auto-
Negotiation
NOTE
l The EGT1 board supports
only Auto-Negotiation, and
1000M Full-Duplex.
l The EFS8 board supports
Auto-Negotiation, and 100M
Full-Duplex.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 Configuring Ethernet Services
Description
Displays all the available ports
on an Ethernet port. The letter
n indicates the number of the
PORT port.
Specifies the name of a PORT
port. The name can contain up
to 32 characters in English or
16 characters in Chinese.
Enabled indicates that this
port is used and services are
available. Disabled indicates
that the services on this port are
not processed. Hence, when
configuring a service, you need
to enable the port to be used.
Specifies the working mode of
the Ethernet port on a board.
This parameter determines the
maximum transmission rate
and communication mode of
the Ethernet port.
When setting this parameter,
you must ensure the working
modes of the interconnected
ports are the same. Otherwise,
the services are not available.
4-131