Configuration Process - Huawei OptiX OSN 550 Configuration Manual

OptiX OSN 550 Multi-Service CPE Optical Transmission
System
Configuration Guide
Parameter
Hub/Spoke

4.9.3 Configuration Process

At the convergence node NE1, you need to create An EVPLAN service (IEEE 802.1q bridge)
and a VLAN filtering table need to be created for the convergence node NE1. The access nodes
NE2 and NE4 need to be configured with EPL transparent transmission services only.
Prerequisite
You must be familiar with
Background Information
If the Ethernet switching boards in the actual application scenarios are different from the boards
in this example, you need to learn about the requirements for configuring specific boards.
l
l
Procedure
Step 1 Configure the EVPLAN services for user G1 and user H1 on NE1.
1.
Issue 02 (2011-06-30)
Forwarding
Physical Port
PORT1
PORT2
VCTRUNK
1
VCTRUNK
2
VCTRUNK
3
VCTRUNK
4
4.3.4 Flow of Configuring EVPLAN
For the EVPLAN services supported by Ethernet switching boards, see
Support Capability of Ethernet
For the VCTRUNK binding requirements of Ethernet switching boards, see
Requirements for Binding Paths with VCTRUNKs on Ethernet
Set the attributes of the external ports (PORT1 and PORT2 on the EFS8 board) used by the
services of user G1 and user H1.
l In the NE Explorer, select the EFS8, and then choose Configuration > Ethernet
Interface Management > Ethernet Interface from the Function Tree.
l Select External Port.
l Click the Basic Attributes tab. After setting the parameters, click Apply.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Ethernet LAN Service of NE1
PORT1, VCTRUNK1,
VCTRUNK2
Hub
Hub
Spoke
Spoke
Hub
Hub
Boards.
4 Configuring Ethernet Services
PORT2, VCTRUNK3,
VCTRUNK4
Services.
6.1 Service
6.2
Boards.
4-101