Huawei OptiX OSN 550 Configuration Manual page 204

4 Configuring Ethernet Services
4-50
Parame Value in This Example Description
ter
FCS VCTRUNK1: Big endian
Calculat
VCTRUNK2: Big endian
ed Bit
Sequenc
e
Set VCTRUNK1: -
Inverse
VCTRUNK2: -
Value
for CRC
l Click the Bound Path tab. Click the Configuration button. Set the following in the
Bound Path Configuration dialog box that is displayed. Then, click Apply.
User Paramete
r
User Configura
A1← ble Ports
→user
Ava Lev
A2
ilab el
le
Bou
nd
Pat
hs
Ser
vic
e
Dir
ecti
on
Av
aila
ble
Res
our
ces
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
OptiX OSN 550 Multi-Service CPE Optical Transmission
When Mapping Protocol is set to GFP, FCS
Calculated Bit Sequence is set to Big
endian. FCS Calculated Bit Sequence of
the VCTRUNKs on the Ethernet boards of
the interconnected equipment at both ends
must be set to the same value.
When Mapping Protocol is set to GFP, this
parameter is valid and adopts the default
value -. Set Inverse Value for CRC of the
VCTRUNKs on the Ethernet boards of the
interconnected equipment at both ends must
be set to the same value.
Value in Description
This
Example
VCTRUN As shown in
K1 by the service between user A1 and user A2.
VC12-xv The service between user A1 and user A2 uses
a 10 Mbit/s bandwidth. Hence, five VC-12s
need to be bound.
For the method of computing the bound
timeslots based on the service bandwidth, see
6.3 Ethernet Service Bandwidths Carried by
VCTRUNKs of Ethernet
Bidirectio The service between user A1 and user A2 is a
nal bidirectional service.
VC4-4 The fourth VC-4 of the EFS8 board can be
bound with VC-12s. In this example, Available
Resources is set to VC4-4.
For the resources used by other boards, see
Requirements for Binding Paths with
VCTRUNKs on Ethernet
Configuration Guide
Figure 4-25, VCTRUNK1 is used
Boards.
Boards.
Issue 02 (2011-06-30)
System
6.2