Huawei OptiX OSN 550 Configuration Manual page 205

OptiX OSN 550 Multi-Service CPE Optical Transmission
System
Configuration Guide
3.
Issue 02 (2011-06-30)
User Paramete
r
Av
aila
ble
Ti
me
slot
s
User Configura
B1← ble Ports
→user
Ava Lev
B2
ilab el
le
Bou
nd
Pat
hs
Ser
vic
e
Dir
ecti
on
Av
aila
ble
Res
our
ces
Av
aila
ble
Ti
me
slot
s
Configure the Ethernet private line services for user A1 and user B1.
l In the NE Explorer, select the EFS8 board, and then choose Configuration > Ethernet
Service > Ethernet Line Service from the Function Tree.
l Click New on the lower-right pane to display the Create Ethernet Line Service dialog
box. Set the following parameters, and then click OK. The Operation Result dialog
box is displayed, indicating that the operation is successful. Click Close.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Value in Description
This
Example
VC12-1 to Five VC-12s need to be bound for the service
VC12-5 from user A1 to user A2. In this example, the
first to the fifth VC-12s need to be selected in
sequence.
VCTRUN As shown in
K2 by the service between user B1 and user B2.
VC12-xv The service between user B1 and user B2 uses
a 20 Mbit/s bandwidth. Hence, 10 VC-12s need
to be bound.
For the method of computing the bound
timeslots based on the service bandwidth, see
6.3 Ethernet Service Bandwidths Carried by
VCTRUNKs of Ethernet
Bidirectio The service between user B1 and user B2 is a
nal bidirectional service.
VC4-4 The fourth VC-4 of the EFS8 board can be
bound with VC-12s. In this example, Available
Resources is set to VC4-4.
For the resources used by other boards, see
Requirements for Binding Paths with
VCTRUNKs on Ethernet
VC12-6 to Ten VC-12s need to be bound for the service
VC12-15 from user B1 to user B2. In this example, the
sixth to the fifteenth VC-12s need to be selected
in sequence.
4 Configuring Ethernet Services
Figure 4-25, VCTRUNK2 is used
Boards.
Boards.
6.2
4-51