Huawei OptiX OSN 550 Configuration Manual page 247

OptiX OSN 550 Multi-Service CPE Optical Transmission
System
Configuration Guide
4.
5.
Issue 02 (2011-06-30)
Parameter Value in
This
Example
Ingress Filter Disabled
l Click Configure Mount.
l In the Available Mounted Ports window, select PORT1, VCTRUNK1, and
VCTRUNK2. Then, click
l Click OK.
l In the Create Ethernet LAN Service dialog box, click OK.
Change the Hub/Spoke attribute of the port that is mounted to the bridge.
NOTE
If normal communication is required between user F2 and user F3, go to
l Select the created bridge and click the Service Mount tab.
l Change the Hub/Spoke attribute of the port that is mounted to the bridge. After setting
the parameters, click Apply.
Parameter Value in
This
Example
Hub/Spoke PORT1: Hub
VCTRUNK
1: Spoke
VCTRUNK
2: Spoke
Configure the cross-connections from Ethernet services (between user F1 to user F2 and
between user F1 to user F3) to the SDH links.
l In the NE Explorer, select NE1 and then choose Configuration > SDH Service
Configuration from the Function Tree.
l Click Create on the lower-right pane to display the Create SDH Service dialog box.
Set the parameters as follows.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 Configuring Ethernet Services
Description
The IEEE 802.1d MAC bridge does not detect the
VLAN tags of the received packets.
.
Description
If user F1 needs to communicate with user F2 and
user F3, PORT1 that accesses the services of user F1
is set to Hub. A port of the Hub attribute can
communicate with a port of the Spoke or Hub
attribute.
If user F2 need not communicate with user F3, set
the two VCTRUNKs that receive the services of
users F2 and F3 to Spoke. Ports of the Spoke
attribute cannot communicate with each other.
Step 1.5.
4-93