Creating The Network - Huawei OptiX OSN 550 Configuration Manual

OptiX OSN 550 Multi-Service CPE Optical Transmission
System
Configuration Guide
About This Chapter
NEs and fibers or cables can be managed on the U2000 only after their topologies are created.
2.1 Creating NEs
Each piece of equipment is represented as an NE on the U2000. Before the U2000 manages the
actual equipment, you need to create the corresponding NEs on the U2000. There are two NE
creation methods, namely, creating a single NE and creating NEs in batches. When you need to
create a large number of NEs, for example, during the deployment, it is recommended that you
use the method of creating NEs in batches. When you need to create only a few NEs, it is
recommended that you use the method of creating a single NE.
2.2 Configuring the NE Data
After an NE is created, you need to configure the data of the NE on the U2000. Otherwise, the
U2000 still cannot manage the NE.
2.3 Checking Board Parameters
To learn about board parameter status, you can check board parameters. Before configuring the
boards in actual networking, you need to check board parameters and ensure that the board
parameters meet the requirements of actual networking.
2.4 Creating Fibers
You can create fibers, serial port cables, extended ECC, and virtual fibers by using the U2000.
2.5 Creating a Topology Subnet
To facilitate network management, you can assign the topology objects in the same network area
or with similar attributes into the same topology subnet.
2.6 Configuring the Protection Subnet
The OptiX OSN equipment supports various network level protection schemes, including the
linear MSP.
2.7 Configuring Clocks
A clock is the basis for the normal operation of an NE. You need to configure the clocks for all
the NEs before configuring services. In addition, you need to configure the clock protection in
the case of a complicated network.
2.8 Clock Configuration Parameters
Issue 02 (2011-06-30)
2
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.

Creating the Network

2 Creating the Network
2-1