Deleting Boards; Modifying Board Configuration Parameters - Huawei OptiX OSN 550 Configuration Manual

OptiX OSN 550 Multi-Service CPE Optical Transmission
System
Configuration Guide
NOTE
If the physical cross-connect board is installed in the subrack, add its corresponding logical board on the
U2000.
----End

5.2.2 Deleting Boards

To modify the network configuration or the NE configuration, you need to delete the boards
from the NE panel.
Prerequisite
l
l
Procedure
Step 1 Double-click the icon of the NE to display the NE Panel.
Step 2 Right-click the board you need to delete and choose Delete from the shortcut menu.
Step 3 Click OK in the Delete Board dialog boxes that are displayed sequentially.
----End

5.2.3 Modifying Board Configuration Parameters

You can modify the existing board configuration data.
Prerequisite
To change the values of different configuration parameters of different boards, you may need
to operate as NM users with different authorities. You must be an NM user with "NE operator"
authority or higher.
Procedure
Step 1 In the NE Explorer, select a board and choose the appropriate function entry from the Function
Tree.
Board Type
SDH board
PDH board
Step 2 In the pane on the right, modify the existing parameter settings and click Apply.
----End
Issue 02 (2011-06-30)
The services and protection groups must be deleted.
You must be an NM user with "NE maintainer" authority or higher.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 Modifying the Configuration Data
Parameter
Laser Switch, Optical(Electrical) Interface
Loopback, VC4 Loopback
Tributary Loopback, Service Load
Indication, Re-timing Mode
5-7