Overhead Byte (Broadcast Data Port) - Huawei OptiX OSN 550 Configuration Manual

7 List of Parameters
Value
F1
Bid-BidType-PortID
Configuration Guidelines
When using the F1 data port, you need to configure its route. That is, set the 64 Kbit/s data being
added to or dropped from the NE, or passing through the NE.
Relationship with Other Parameters
You can correctly set the F1 data ports that have the same direction only when the F1 port is not
set to Transparent ECC Overhead Transmission.

7.108 Overhead Byte (Broadcast Data Port)

Description
The Overhead Byte (Broadcast Data Port) parameter specifies the number of the overhead
bytes, which are used to transmit orderwire broadcast data services, in the SDH frame header.
Impact on the System
The system operation is not affected.
Values
Valid Values
SERIAL1, SERIAL2,
SERIAL3, SERIAL4
The following table lists the description of each value.
Value
SERIAL1
SERIAL2
SERIAL3
SERIAL4
7-86
OptiX OSN 550 Multi-Service CPE Optical Transmission
Description
Indicates the F1 data port of the NE.
Indicates a port that can be used to set a slot of the F1 data
port.
Default Value
SERIAL1
Description
Indicates the S1 byte in the SDH frame header.
Indicates the S2 byte in the SDH frame header.
Indicates the S3 byte in the SDH frame header.
Indicates the S4 byte in the SDH frame header.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
System
Configuration Guide
Issue 02 (2011-06-30)