Fujitsu M10 Installation Manual page 114

Figure 3-30 Mounting the chassis in the rack
B
FRONT FRONT
8.
Attach the cable management arm (referred to below as CMA).
The work of attaching the CMA is as viewed from the rear of the rack.
a. Slide to remove the bracket marked "CMA Release For ..." from the CMA, and
Figure 3-31 Attaching the bracket
b. Insert the smaller bracket (C in
c. Insert the larger bracket (D in
Fujitsu M10/SPARC M10 Systems Installation Guide ･ July 2015
100
insert it into the slide rail along the grooves on the left side of the chassis.
right-edge clip portion (A in
the chassis.
A
Figure 3-32) on the tip of the CMA into the
Figure 3-32) of the inner rail on the right side of
Figure 3-32) on the tip of the CMA into the right