root-dom0 active -n--v- 5000 24 24G 0.0% 2h 29m
root-dom1 inactive ------ 24 24G
c. Confirm all the I/O devices of the building block to be removed are released.
# ldm list-io
NAME TYPE BUS DOMAIN STATUS
---- ---- --- ------ ------
PCIE0 BUS PCIE0 primary IOV
PCIE1 BUS PCIE1 root-dom0IOV
PCIE2 BUS PCIE2 root-dom0IOV
PCIE3 BUS PCIE3 root-dom0IOV
PCIE4 BUS PCIE4 primary IOV
PCIE5 BUS PCIE5 root-dom0IOV
PCIE6 BUS PCIE6 root-dom0IOV
PCIE7 BUS PCIE7 root-dom0IOV
PCIE8 BUS PCIE8
PCIE9 BUS PCIE9
PCIE10 BUS PCIE10
PCIE11 BUS PCIE11
PCIE12 BUS PCIE12
PCIE13 BUS PCIE13
PCIE14 BUS PCIE14
PCIE15 BUS PCIE15
(Omitted)
7.
Go back to the XSCF shell and confirm the system board status of the SPARC
M10-4S to be removed.
Execute the showboards command to check the system board status.
Confirm that the system board of the SPARC M10-4S to be removed is in the
Assigned state and "y" is displayed for all of the [Pwr], [Conn], and [Conf]
columns.
XSCF> showboards -p 0
PSB PPAR-ID(LSB) Assignment Pwr Conn Conf Test Fault
---- ------------ ----------- ---- ---- ---- ------- --------
00-0 00(00) Assigned y y y Passed Normal
01-0 00(01) Assigned y y y Passed Normal
8.
Release the system board from the physical partition.
a. Execute the deleteboard command to release the system board (PSB) from
XSCF> deleteboard -c unassign 01-0
PSB#01-0 will be unassigned from PPAR immediately. Continue?[y|n] : y
Start unconfigure preparation of PSB. [1200sec]
Fujitsu M10/SPARC M10 Systems Installation Guide ・ July 2015
286
Execute the ldm list-io command to confirm that the I/O devices are released.
the physical partition.
The following example releases system board 01-0 from the physical partition
to be in the system board pool.