Figure 6-2 Mode switch on the operation panel of the SPARC M10-4/SPARC
Note - The operation panel of the SPARC M10-4 does not have the area enclosed by the
dashed line.
Figure 6-3 Mode switch on the operation panel of a crossbar box
2.
Confirm that the power cord connector is connected to a power supply unit of
the chassis.
3.
Connect the power cord plug to an outlet.
a. If the outlet has a circuit breaker, turn on the circuit breaker switch.
Fujitsu M10/SPARC M10 Systems Installation Guide ・ July 2015
180
M10-4S
Locked
Service
Locked
Service