Fujitsu M10 Installation Manual page 272

XSCF> showcod -p 0
PROC Permits assigned for PPAR 0: 64
c. If the assigned resources are insufficient, execute the setcod command to
XSCF> setcod -p 0 -s cpu 128
d. If you have assigned CPU resources, execute the showcod command
XSCF> showcod -p 0
PROC Permits assigned for PPAR 0: 128
11. Check the operation status of logical domains.
a. Connect to the control domain console of the physical partition, and then
XSCF> console -p 0
b. Execute the ldm list-domain command to check the operation status of the
# ldm list-domain
NAME STATE FLAGS CONS VCPU MEMORY UTIL UPTIME
primary active -n-cv- UART 32 28G 0.0% 2h 3m
guest0 active -n---- 5100 64 64G 3.1% 33m
root-dom0 active -n--v- 5000 32 32G 3.1% 47m
12. Incorporate the system board of the installed SPARC M10-4S into the physical
partition.
Note - Suppose you install the installed SPARC M10-4S together with a PCI expansion unit
Fujitsu M10/SPARC M10 Systems Installation Guide ･ July 2015
258
assign CPU resources to the physical partition.
The following example assigns 128 CPU core resources to the physical partition.
again to check the information on the CPU resources assigned to the
physical partition.
log in.
logical domains.
Check the operation status of the logical domains through the combination of
[STATE] and [FLAGS]. When [STATE] is "active," the second character from
the left of the string in [FLAGS] has one of the following meanings:
"n": Oracle Solaris operating
"t": OpenBoot PROM state
"-": Another state (including cases in which STATE is not active)
In the following example, you can see that the control domain, one guest
domain, and one root domain are operating.