XSCF> diagxbu -y -b 0 -t 1
XBU diagnosis is about to start, Continue?[y|n] :y
Step 1(total 3 steps) started. [1800sec]
0..... 30..... 60..... 90.....120end
completed.
.
.
Step 3(total 3 steps) started. [1200sec] 0..... 30..... 60..... 90.....120end
completed.
*Note*
Please confirm the error of XBU by "showlogs error".
In addition, please confirm the degraded of XBU by "showstatus".
XSCF>
A.3
How to Restore a BB-ID from an
Incorrect Setting
If a BB has an incorrectly set BB-ID, it does not start up normally when the input
power is turned on. This section describes the procedures for restoring a BB-ID.
A.3.1
BB-IDs not set (BB-ID 00)
If all BB-IDs have been left as 00 without being set when the input power is turned
on, restore them according to the following procedure.
Fujitsu M10/SPARC M10 Systems Installation Guide ・ July 2015
316