Fujitsu M10 Installation Manual page 38

Standalone configuration (SPARC M10-1 or SPARC
M10-4)/building block configuration (direct connection between
each SPARC M10-4S chassis)
Each chassis of the SPARC M10 systems is designed for mounting in an equipment
rack.
If the SPARC M10-4S units are connected by cables, mount the units side by side in a
rack with no gap between them.
Figure 2-3 Chassis mounting locations (corresponding to BB-IDs) for the 4BB
Note - For the SPARC M10-4 and M10-4S, the cable support at the chassis rear moves
underneath the chassis during maintenance, so do not mount the chassis on the lowest shelf
(1U) of the rack.
For mounting in a third-party rack, it is the customer's responsibility to confirm that
the rack specifications match the specifications and requirements for the SPARC M10
systems (see
Note - The dimensions shown in the conditions do not include any protrusions.
Fujitsu M10/SPARC M10 Systems Installation Guide ･ July 2015
24
configuration
BB#03
BB#02
BB#01
BB#00
1U
Table 2-3 and Figure 2-4).