Fujitsu M10 Installation Manual page 265

1.
Log in to the master XSCF.
Execute the showbbstatus command to confirm that the XSCF to which you have
logged in is the master XSCF.
If it is a standby XSCF, retry to log in to the master XSCF.
XSCF> showbbstatus
BB#00 (Master)
2.
Execute the showsscp command to check whether the IP address of the SP to
SP communication protocol (SSCP) is a default value or a value set by a user.
XSCF> showsscp
Note - For details on the default SCCP IP address, see "3.7.5 Understanding the IP addresses
that are set with SSCP" in the Fujitsu M10/SPARC M10 Systems System Operation and
Administration Guide.
If the IP address is a default value and the default value should also be used for
the IP address of the SPARC M10-4S to be installed, go to the next step.
To set a user value, use the setsscp command to set an IP address, use the
applynetwork command to apply the SSCP IP address of the target SPARC
M10-4S, and confirm that it was reflected. Then, execute the rebootxscf
command to complete settings, and go to the next step. For details on the
procedure, see
3.
Execute the poweroff command to stop the physical partition that is the
incorporation destination of the installed SPARC M10-4S.
Specify the physical partition number of the incorporation destination in ppar_id.
XSCF> poweroff -y -p ppar_id
XSCF> poweroff -y -p 0
PPAR-IDs to power off:00
Continue? [y|n]:y
00:Powering off
*Note*
This command only issues the instruction to power-off.
The result of the instruction can be checked by the "showpparprogress".
4.
Install the SPARC M10-4S.
a. Execute the addfru command, and install the SPARC M10-4S by following
Note - If no SSCP IP address is set, an error occurs.
"7.5.6 Applying network
The following example stops PPAR#0.
the messages.
Chapter 9 Installing a System with a Building Block Configuration
settings."
251