Execute the setpcl command to register the system board of the installed
SPARC M10-4S in the physical partition configuration list for the incorporation
destination.
The following example associates physical system board (PSB) 01-0 with
logical system board (LSB) 01 of physical partition 0.
XSCF> setpcl -p 0 -a 01=01-0
c. Execute the showpcl command, and confirm the set physical partition
configuration list.
XSCF> showpcl -p 0
PPAR-ID LSB PSB Status
00 Running
00 00-0
01 01-0
8.
Register a CPU Activation key, and assign CPU core resources.
a. Execute the showcodusage command to display the CPU Activation key
information.
The following example displays the CPU Activation key information.
XSCF> showcodusage -p resource
Resource In Use Installed CoD Permitted Status
-------- ------ --------- ------------- ------
PROC 64 64 128 OK: 64 cores available
Note - If the number of registered CPU Activation keys is insufficient for the number of CPU
cores to be used, request the customer to purchase CPU Activations to add CPU Activation
keys. For details on adding a CPU Activation key, see
key."
b. Execute the showcod command to check the CPU resource information for
the physical partition.
XSCF> showcod -p 0
PROC Permits assigned for PPAR 0: 64
c. If the assigned resources are insufficient, execute the setcod command to
assign CPU resources to the physical partition.
The following example assigns 128 CPU core resources to the physical partition.
XSCF> setcod -p 0 -s cpu 128
d. If you have assigned CPU resources, execute the showcod command
Chapter 9 Installing a System with a Building Block Configuration
"7.11.3 Registering a CPU Activation
247