Fujitsu M10 Installation Manual page 278

-s: Executes the "show-devs" command of OpenBoot PROM and displays the
-a: Diagnoses all the mounted PSBs
-y: Automatically responds with "y" to a query
XSCF> testsb -v -p -s -a -y
Initial diagnosis is about to start, Continue?[y|n] :y
SB power on sequence started.
POST Sequence 01 Banner
If an error is displayed, see
Note - A cable check with the diagxbu command is not necessary because this command
with the -a option specified performs a diagnosis test on all the mounted system boards
(PSBs).
16. Execute the showlogs error command, and confirm that no error is displayed.
XSCF> showlogs error
If an error is displayed, see
17. Execute the showhardconf command from the master XSCF to check the
configuration, status, and quantities.
For details, see
18. If the installation expanded the 1BB configuration to a multiple-BB configuration,
configure the XSCF network.
For details, see
Setting a takeover IP
After configuration, execute the applynetwork command to apply the settings,
and confirm that they were reflected. Then, execute the rebootxscf command to
complete settings, and go to the next step. For details on the procedure, see
"7.5.6 Applying network
19. To configure memory mirroring for the installed SPARC M10-4S, set memory
mirror mode.
For details, see
20. Create physical partition configuration information.
For details, see
21. Add the system board (PSB) to the physical partition.
For details, see
(PPAR)."
22. Check the CPU Activation key information, and assign CPU resources to the
physical partition.
For details, see
23. Execute the poweron command to start the system.
Fujitsu M10/SPARC M10 Systems Installation Guide ･ July 2015
264
results while a diagnosis is being processed
"6.8 Checking the Component
"7.5.2 Setting an Ethernet (XSCF-LAN) IP
address."
"7.6 Configuring Memory
"7.7 Creating a Physical Partition Configuration List
"7.8 Assigning a System Board (PSB) to a Physical Partition
"7.11 Registering a CPU Activation
"A.2.4 Checking diagnosis
"A.2.2 Checking the contents of
Status."
settings."
Mirroring."
results."
logs."
address" and "7.5.3
(PCL)."
Key."