Fujitsu M10 Installation Manual page 131

b. Slide in the cable support all the way, and tighten the four screws (C in
3-57).
Figure 3-57 Attaching the cable support (2)
C
Note - If the dimension between the front and rear columns of the rack is less than 740 mm,
secure the cable support without sliding it in all the way. The fixing location varies
depending on the dimension between the front and rear columns of the rack. Based on
Figure 3-58, align the scale marks (E in
with the screws (F in Figure
Figure 3-58 Attaching the cable support (3)
Scale position 1st
Scale position 10th
Scale
position 6th
F
Table 3-10 Dimensions between the front and rear columns and scale positions
Dimension between front and rear columns (mm)
740
Figure 3-58) (spacing: 10 mm) on the cable support
3-58) of the fixing brackets to secure the cable support.
E
Scale position
1st
REAR
REAR
Chapter 3 Installing the System
Figure
117