Fujitsu M10 Installation Manual page 202

1.
Execute the testsb command.
The testsb command performs an initial diagnosis of the specified physical
system board (PSB).
The command powers on and off the PSB during the diagnosis. By specifying
options, you can check whether HDD/SSD/PCI cards are mounted. You can also
check the crossbar cable connections in a building block configuration.
The following example performs an initial diagnosis of all mounted PSBs and
checks the connection I/O.
<Description of options specified>
-v: Additionally displays detailed messages of the initial diagnosis
-p: Executes the "probe-scsi-all" command of OpenBoot PROM and displays the
-s: Executes the "show-devs" command of OpenBoot PROM and displays the
-a: Diagnoses all the mounted PSBs
-y: Automatically responds with "y" to a query
XSCF> testsb -v -p -s -a -y
Initial diagnosis is about to start, Continue?[y|n] :y
SB power on sequence started.
POST Sequence 01 Banner
LSB#00: POST 1.9.0 (2012/09/25 16:52)
:
<< Displayed execution results of "probe-scsi-all">>
/pci@8000/pci@4/pci@0/pci@0/scsi@0
FCode Version 1.00.56, MPT Version 2.00, Firmware Version 13.00.66.00
Target a
Unit 0 Disk TOSHIBA MBF2600RC 3706 1172123568 Blocks, 600 GB
SASDeviceName 50000394281b6190 SASAddress 50000394281b6192 PhyNum 0
Target d
Unit 0 Disk TOSHIBA MBF2600RC 3706 1172123568 Blocks, 600 GB
SASDeviceName 50000394281b5a44 SASAddress 50000394281b5a46 PhyNum 1
<< Displayed execution results of "show-devs">>
/pci@8100/pci@4/pci@0/pci@1
/pci@8100/pci@4/pci@0/pci@1/QLGC,qlc@0,3
/pci@8100/pci@4/pci@0/pci@1/QLGC,qlc@0,2
/pci@8100/pci@4/pci@0/pci@1/ethernet@0,1
/pci@8100/pci@4/pci@0/pci@1/ethernet@0
/pci@8100/pci@4/pci@0/pci@1/QLGC,qlc@0,3/fp@0,0
/pci@8100/pci@4/pci@0/pci@1/QLGC,qlc@0,3/fp@0,0/disk
/pci@8100/pci@4/pci@0/pci@1/QLGC,qlc@0,2/fp@0,0
/pci@8100/pci@4/pci@0/pci@1/QLGC,qlc@0,2/fp@0,0/disk
:
PSB Test Fault
Fujitsu M10/SPARC M10 Systems Installation Guide ･ July 2015
188
results while a diagnosis is being processed
results while a diagnosis is being processed