Fujitsu M10 Installation Manual page 16

Table 1-1 Workflow for the SPARC M10-1 (continued)
Step (work time (*1)) Work description
2 Before installing the system, check
the safety precautions, system
specifications, and necessary
conditions for installation.
3 Prepare the necessary tools/
information for installation.
4 Confirm the delivered components.
5 Install the rack.
6 Mount the chassis in the rack.
7 If there are optional components,
mount them on the chassis.
8 Connect serial cables, LAN cables,
and power cords to the chassis.
Initial diagnosis (approx. 30 minutes)
9 Connect the system management
terminal to the chassis, and turn on
the input power.
10 Log in to the SPARC M10-1, and
check the firmware version number,
altitude setting, and time setting.
11 Perform an initial diagnosis test on
the physical system board (PSB).
12 Check the status of mounted
components.
Initial system settings (approx. 50 minutes)
13 Set the password policy.
14 Set a user account and password.
15 Configure the telnet or SSH service.
16 Configure the HTTPS service.
17 Configure the XSCF network.
18 When duplicating memory,
configure memory mirroring.
Fujitsu M10/SPARC M10 Systems Installation Guide ･ July 2015
2
Reference
"Chapter 2 Planning and Preparing
for System Installation"
"3.1 Preparing the Necessary
Tools/Information for Installation"
"3.2.1 Confirming the delivered
components of the SPARC
See the manual for each rack.
"3.3.2 Securing the rack"
"3.4.1 Mounting the SPARC M10-1
in a rack"
"3.5.1 Mounting optional
components in the SPARC
"5.1 Connecting Cables to the
SPARC M10-1"
"6.1 Connecting the System
Management Terminal to the Chassi
s"
"6.2.2 Turning on the input power
and starting the XSCF"
"6.3 Logging In to the XSCF"
"6.4 Checking the XCP Version"
"6.5 Checking the Altitude
"6.6 Checking the Time
"6.7 Performing a Diagnosis
"6.8 Checking the Component
Status"
"7.1 Setting the Password
"7.2 Setting a User Account and
Password"
"7.3 Configuring the Telnet/SSH
Service"
"7.4 Configuring the HTTPS
Service"
"7.5 Configuring the XSCF
Network"
"7.6 Configuring Memory
Mirroring"
Required
Required
Required
M10-1"
Required
Required
Optional
M10-1" (*3)
Required
Required
Required
Setting"
Setting"
Test" Required
Required
Policy" Required
Required
Required
Required
Required
Optional