Fujitsu M10 Installation Manual page 373

Table C-1 XSCF setup command examples (continued)
XSCF command example
showcod -v -s cpu
Starting and stopping a physical partition
setpparparam -p 0 -s
bootscript "setenv
auto-boot? false"
poweron -a
showpparprogress -p 0
showdomainstatus -p 0
console -p 0
poweroff -a
showpparprogress -p 0
*1 If you execute the setdate command after setting the altitude, you can skip rebootxscf because the XSCF is automatically reset after the
command is executed.
Description
Checks the number of assigned CPU
Activations
Changes the setting of auto-boot?,
which is an OpenBoot PROM
environment variable
Starts a physical partition
Displays the physical partition status
Example: The progress between
PPAR-ID 0 power-on and the start of
POST is displayed in the midst of
processing.
Displays the logical domain status
Example: The status of all logical
domains on PPAR-ID 0 is displayed.
Connects to the control domain
console of a physical partition (PPAR)
Stops a physical partition
Displays the physical partition status
Mandatory? Linked section
Yes "7.12 Assigning CPU Core
Resources"
Yes "7.13 Starting and Stopping a
Physical Partition
Yes "7.13 Starting and Stopping a
Physical Partition
Yes "7.13 Starting and Stopping a
Physical Partition
Yes "7.13 Starting and Stopping a
Physical Partition
Yes "7.13 Starting and Stopping a
Physical Partition
Yes "7.13 Starting and Stopping a
Physical Partition
Yes "7.13 Starting and Stopping a
Physical Partition
Appendix C Setup Command Workflow
(PPAR)"
(PPAR)"
(PPAR)"
(PPAR)"
(PPAR)"
(PPAR)"
(PPAR)"
359