Adding Expansion Racks 1 And 2 - Fujitsu M10 Installation Manual

17. Perform an initial setup of the installed chassis.
For details, see the following.
-
-
-
-
-
18. Reconfigure the logical domains.
Assign the resources of the installed SPARC M10-4S to an existing logical
domain or a newly configured logical domain. For details, see the Fujitsu
M10/SPARC M10 Systems Domain Configuration Guide.
9.5

Adding Expansion Racks 1 and 2

This section describes the procedure for adding expansion racks 1 and 2 and
changing the connection configuration from direct connections between chassis to
connections through crossbar boxes (the 9BB configuration to the 16BB configuration).
This procedure corresponds to pattern C in
9.5.1 Changing a multiple-BB configuration into 1BB
configurations and releasing their connections
Remove the SPARC M10-4S from the existing multiple-BB configuration (direct
connections between chassis), change it to 1BB configurations, and release their
connections.
To move the SPARC M10-4S to an expansion rack, stop the entire system and then
perform the work.
Note the following points on this work.
All the system setting information will be cleared and reset to the factory defaults.
■
Before removing the SPARC M10-4S, save the system setting information with the
dumpconfig command. In case of resetting the configuration to the original
setting, you can restore the saved setting information to XSCF by using the
restoreconfig command.
Multiple SPARC M10-4S units cannot be released from the system by using the
■
initbb command at the same time.
The serial number of the chassis of either the master XSCF or standby XSCF is
■
used as the system serial number. If the serial number of the standby chassis is
being used as the system serial number, the initbb command cannot release the
standby chassis. In this case, execute the switchscf command to switch the master
XSCF.
"7.6 Configuring Memory
"7.7 Creating a Physical Partition Configuration List
"7.8 Assigning a System Board (PSB) to a Physical Partition
"7.11 Registering a CPU Activation
"7.12 Assigning CPU Core
Chapter 9 Installing a System with a Building Block Configuration
Mirroring"
Key"
Resources"
Figure 8-2.
(PCL)"
(PPAR)"
271