3-4
Assume that a UNIVERGE SV9100 is added to the existing data network. The
Network Administrator (or IT Manager) should provide the following:
IP Address (for the GCD-CP10 blade)
IP Addresses (for the GPZ-IPLE daughter board)
Subnet Mask
Default Gateway
A spare switch/hub port
First, program the UNIVERGE SV9100:
192.168.1.200
255.255.255.0
PRG10-12-03: 192.168.1.254
A system reset is required for the IP Address changes to take effect.
Now connect the GCD-CP10 blade Ethernet Port to the switch/hub port, using a
standard Cat-5 patch cable. The UNIVERGE SV9100 is now configured on the
network and should be accessible by other devices on the network. Refer to
Figure 3-2 Example Configuration 1 - Adding the UNIVERGE SV9100 Chassis to
the
Network.
Issue 2.0
General IP Configuration