NEC Univerge SV9100 Manual page 103

Program
Number
26-01-01 Automatic Route Selection Service – ARS
Service
ARS must be enabled in all system for this
feature to work.
26-01-06 Automatic Route Selection Service – Class
of Service Match Access
With the ARS Class of Service Match Access
feature, you can determine whether or not the
system should allow a call based on the COS
assigned to the Dial Analysis Table (Program
26-02).
This change can be used to create a tenant-like
application. It then uses the trunk group set in
the Additional Entry in Program 26-02-03 to
place the out-going call.
When this feature is enabled, the calls are
routed in sequential order, and forward –
provided the Class of Service for the trunk
groups match.
26-01-07 Automatic Route Selection Service –
F-Route Access COS Reference
Define where the system looks for the
Automatic Route Selection (ARS) class of
service.
26-02-01 Dial Analysis Table for ARS/LCR – Dial
Enter the digits (16 digits maximum: 1~9, 0, #,
@; 800 separate entries) for the Dial Analysis
Table which is analyzed by ARS/LCR.
This table is checked after any programmed F-
Route operations have completed.
The system then refers to Program 26-02-02
and Program 26-02-03 to determine the routing
for the call.
To enter a wild card/don't care digit, press Line
Key 1 to enter an @ symbol. It is important to
remember that the system checks the table
numbers in numerical order.
This means that entries for specific numbers
should be entered first (such as your local area
codes), then enter the items containing wild
card digits. If the system sees an entry of
2@@, any table entries which follow are
ignored.
For example, if 268, 269, and 270 are local
exchanges, these would be the first three table
entries which route according to the settings
made in Program 26-02-02 and Program 26-02-
03 for each of the table entries. If the next entry
is 2@@, the system checks no further in this
program and routes all other 2xx numbers
according to the entries made in Program 26-
02-02 and Program 26-02-03 for this table
entry.
4-24
Program Name/Description Input Data
0 = Disabled (ARS service is
Off)
1 = Enabled (ARS service is On)
0 = Disable (Off)
1 = Enable (On)
0 = F-Route
1 = ARS
Dial a maximum of 16 digits
(0 ~ 9, #, @)
Features and Specifications
Issue 2.0
Default
Default = 0
Default = 0
Default = 0
Default = No
Setting