NEC Univerge SV9100 Manual page 538

Issue 2.0
Programming
This section lists each program in numerical order. For example, Program 10-01 is at
the beginning of the section and Program 92-01 is at the end. The information on
each program is subdivided into the following headings:
Description describes what the program options control. The Default Settings for
each program are also included. When you first install the system, it uses the Default
Setting for all programs. Along with the Description are the Conditions which
describe any limits or special considerations that may apply to the program.
The reverse type (white on black) just beneath the Description heading is the
program access level. You can use the program only if your access level meets or
exceeds the level the program requires. Refer to
Programming Mode on page 10-52
passwords.
Feature Cross Reference provides you with a table of all the features affected by
the program. You should keep the referenced features in mind when you change a
program. Customizing a feature may have an effect on another feature that you did
not intend.
Telephone Programming Instructions shows how to enter the program data into
system memory. For example:
1.
2.
SV9100 Networking Manual
Default Setting
No SIP Trunks are defined
Enter the programming mode.
Dial 150701 from the telephone dial pad. The message 15-07-01 TEL is displayed
on the first line of the telephone display.
15-07-01 TEL
KY01 = *01

This indicates the program number (15-07), item number (01), and that the options
are being set for the extension. The second row of the display KY01 =
that Key 01 is being programmed with the entry of
move the cursor to the left or right, depending on which arrow is pressed. To learn
how to enter the programming mode, refer to
Mode on page 10-52.
Section 18 How to Enter
for a list of the system access levels and
01. The third row allows you to

Section 18 How to Enter Programming
01 indicates

10-51