NEC Univerge SV9100 Manual page 98

Issue 2.0
K-CCISoIP License (5012)
S
ERVICE
General:









SV9100 Networking Manual
C
ONDITIONS
The originating system must have a dial treatment of D019RE where 9 is the
ARS trunk access code in the destination system for this feature to work.
ARS must be enabled in all systems for this feature to work.
The CCIS Call Rerouting feature is not supported on stations using 3rd party
CTI.
The CCIS Call Rerouting feature is not supported on a station which is
controlled by 1st party CTI.
The CCIS Call Rerouting feature will not work if Line Load Control has been
triggered on the destination system.
The CCIS Call Rerouting feature is only supported on CCISoIP with SV9100
systems.
The CCIS Call Rerouting feature can only use the four routing options
contained in one F-Route table.
The CCIS Call Rerouting feature cannot fall through from one F-Route table to
a second F-Route table.
If none of the four F-Route table route priorities are available the outbound call
will fail.
4-19